; APERTURE FILE FORMAT
;
; <draft code> <shape> <xsize> <ysize> <hole size> <use>
;
; EXPLANATION OF PARAMETERS
;
; <draft code>   Code assigned to this aperture e.g. D14
;                Note that this code must start with 'D'
;                followed by the code number.
;
; <shape>        Can be any of the following shapes:
;                         CIRCULAR
;                         RECTANGULAR
;                         SQUARE
;                         OCTAGONAL
;                         ROUNDRECT
;                         CROSSHAIR
;                         MOIRE
;
; <xsize>        size of aperture in the x direction in
;                mils (thous).
;
; <ysize>        size of aperture in the y direction in
;                mils (thous).
;
; <hole size>    size of hole in aperture in mils (thous).
;                zero if no hole in aperture.
;
; <use>          specifies what the aperture can be used for.
;                There are three possible settings:
;                   LINE   can only be used to draw lines
;                   FLASH  can only be used to flash pads
;                   MULTI  can be used for either
;                   blank  defaults to MULTI setting
;
D11 CIRCULAR     40  40  0
D12 SQUARE       10  10  0
D13 CIRCULAR     10  10  0
D14 CIRCULAR     12  12  0
D15 CIRCULAR     15  15  0
D16 SQUARE       20  20  0
D17 CIRCULAR     20  20  0
D18 CIRCULAR     25  25  0
D19 CIRCULAR     30  30  0
D20 SQUARE       50  50  0
D21 CIRCULAR     50  50  0
D22 SQUARE       62  62  38
D23 CIRCULAR     62  62  32
D24 CIRCULAR     70  70  0
D25 CIRCULAR     75  75  0
D26 CIRCULAR     85  85  0
D27 CIRCULAR    100 100  0
D28 CIRCULAR    110 110  0
D29 CIRCULAR    125 125  38
D30 CIRCULAR    150 150  150
D31 CIRCULAR    200 200  0
D32 CIRCULAR    250 250  0
D33 CIRCULAR     40  40  10
D34 ROUNDRECT   120  60  32 FLASH
D35 ROUNDRECT    60 120  32
D36 CIRCULAR      8   8  0
D37 CIRCULAR      5   5  0